User manual

User Manual Baxall Vivid Viewer Application
9
MAIN DISPLAY TOOLBAR
The main display toolbar controls camera selection and display.
1. Picture-in-picture
This button allows a picture-in-picture (PIP) display to be selected.
• Click the picture-in-picture (PIP) button
• Subsequent presses of the PIP button will move the picture-in-picture cameo around the main display area as shown
below.
2, 3, 4 and 5. Quad displays
These buttons allow up to four cameras to be displayed in a 4 x 4 matrix. To activate quad mode, click one of the four quad
buttons.
Button A will display cameras 1, 2, 3 and 4; button B will display cameras 5, 6, 7 and 8; button C will display cameras 9, 10, 11
and 12; button D will display cameras 13, 14, 15 and 16. The currently selected button will be indicated by a pale green highlight
(button A in the example above).
6. Sequence
The Vivid DVR can display all of the cameras connected to it in sequence. Each camera will be displayed by the viewer
application for a short period of time. To start camera sequencing:
• Select a camera in single camera view mode (sequencing can start from any camera).
• Press the sequence button.
To stop sequencing:
• Select a camera for full screen viewing by clicking the Single camera button (or by selecting any Quad display or PIP).
7. Single Camera
Clicking this button activates the single camera view mode. A camera can be selected from the Select Camera pull-down for
display.
To select a single camera in full screen mode:
• Click the Single camera button
• Select the camera to be displayed from the camera pull-down.
Alternatively, if the viewer is showing a quad display and the camera you wish to view full-screen is being displayed in one of
the four cameos, simply double-click the cameo to display that camera full-screen.
8. Select Camera
Allows you to select any of the cameras connected to the Vivid DVR for display in full-screen mode.