User manual

Baxall Vivid Viewer Application User Manual
6
SETTING UP A NEW CONFIGURATION FILE (SITE)
Site Name - allows entry of a site name consisting of up to 16 alphanumeric characters.
Location - allows entry of a location consisting of up to 30 alphanumeric characters.
IP Address - displays the Vivid DVR’s IP address entered during step 5.
Cameras - allows you to select the number of cameras from a pull down list (for information purposes only)
User Passcode and Installer Passcode - If User and/or Installer passwords have been entered in these fields then the
viewer application will automatically carry out password verification according to the type of login used (User or Administration).
If no passwords have been entered, then the password validation window will be displayed for you to enter the Vivid DVR’s
password. If, when logging on to the viewer application, the password entered is a ‘User’ type password, then you will be
logged on to the Vivid DVR as a ‘user’ (rather than as an administrator).
PT sp - this field allows you to vary the telemetry response to compensate for network latency so that networks with limited
bandwidth do not have telemetry response times resulting in control overshoot. Select a value between 1 and 4.
Poll - allows automatic polling to be enabled or disabled. Ticking the box enables automatic polling for the connected Vivid
DVR.
Status - shows the status for the connected Vivid DVR.
indicates that the device is disconnected; indicates that the
device is connected.
7. If the status of the device shows ‘connected’, click the Save and Exit button in the Viewer Configuration window.
8. The System Login window will reappear. Enter the password.
9. Select the site from the pull-down box in the main window of the viewer application. The message ‘Connecting to DVR’ will
appear in the status bar (bottom left-hand corner of the main window).