User manual

User Manual Baxall Vivid Digital Video Recorder

CONFIGURE DISPLAY

Spot Monitor Settings

Selecting Spot monitor from the Configure display menu will open a menu similar to the following:

All settings available within this menu are exactly the same as for the Main Monitor Settings menu.

ALARM STATUS

These pages allow you to manually acknowledge alarm or motion detection events. The default page shows information for

Alarm events. Selecting Motion on this page opens a similar page detailing motion detection events. A typical alarm status

page is shown below.

To manually clear an alarm

1. Used the up/down arrow keys to select the alarm or motion event to be cleared (if there is more than one)

2. Press the enter key to clear the selected alarm or motion event.

3. The ‘In progress’ caption will change to ‘Manually cleared’.

Monitor type Overscan

Sequenced Yes

Sequence

Dwell time 4s

On-screen display setup

Alarm Status

1 Alarming Timed Out

2 Alarming In progress Clear alarm

3 Disabled -

4 Disabled -

5 Disabled -

6 Disabled -

7 Disabled -

8 Disabled -

9 Disabled -

10 Disabled -

11 Disabled -

12 Disabled -

13 Disabled -

14 Disabled -

15 Disabled -

16 Disabled -

Back to menus Motion