Operating instructions

Page 20
Appendix A - Configuring your Slave Matrices
To configure Slave matrices, it is necessary to open your matrices and
define the slave number. The procedure is detailed below:
Note : This operation is best done before you connect the cables.
CAUTION : Take normal ESD (Electro-Static-Discharge) precautions
during this procedure to prevent damage to your Matrix.
• Ensure that your Matrix is switched off
• Remove the securing screws, keep the screws safe, (figure 2) and fold
down the hinged Matrix door (the top, as shown in figure 2, moves
towards you)
48M16
remove
screw
remove
screw
Figure A
• Arrange the jumpers in your Slave Matrix (see figure B for location)
according to figure C.
Master/Slave
Links
Figure B
Keep a record of which Matrix is which to save opening them at a later
date.
Master and
Slave #1
Slave #2
Slave #3
Figure C. Jumper settings in the master and slaves
• Close and fasten your matrices.