Operating instructions

Page 14
5. Multiplexer Connection
5.1 Baxall ZMX-9/16
CAUTION :
Disconnect the power from all units before connecting
the serial ports.
To connect a ZMX-IT multiplexer to the Matrix Serial port:
• Wire the RS232 lead according to figure 9.
• Connect the female plug to a serial port on your Matrix
• Connect the Male plug to the RS232 connector on your ZMX-IT
• Connect the Monitor A BNC on your ZMX-IT to a video input on
your Matrix.
Figure 5. RS232 Lead Wiring
• Install your ZMX-IT according to its own instructions
Note: Keep a record of the connection numbers for future reference.
• See section 7 for detail on how to configure the serial ports.