Operating instructions

Page 12
4.6 Connecting the Network
See Manual 2 - Network Wiring
The network plug provided has five terminals. Figure 8 shows the
network connections.
Figure 4. Network Connections
• Connect your Master Matrix to the network.
• Connect the cable screen to GND on pin 3.
4.7 Switching on the Power
Each Matrix has a typical power consumption of 9 watts and requires a
class 2 isolated supply between 9V DC and 15V DC.
WARNING:
Only use the power supply specifically provided by Baxall
for a Pyramid Matrix.
• Connect your matrices to the power supplies provided.
If your power is correctly connected then the power LED lights.
To power a Master/Slave system
• Connect power to the Slave matrices before you power the Master
Matrix
Upon power-up the monitors should display the following screen for 30
seconds: