Operating instructions

Page 10
4.3 Connecting Video to an Single Matrix
All video connections must be via 75 ohm BNC connectors and video
coaxial cable.
Referring to Figure 1,
• Connect your cameras to video inputs 1 to 48.
• Connect video outputs 1 to 16 to your monitors or other equipment.
4.4 Connecting Video to a Master/Slave system
All video connections must be via 75 ohm BNC connectors and video
coaxial cable. The matrices should have been configured as their
relevant Slave numbers according to section 4.2.
On figure 6 each block represents 16 BNC to BNC connections.
Figure 2
You can connect 1, 2 or 3 slaves:
• Connect the slave 1 monitor outputs 1 to 16 to camera inputs 1 to 16
respectively on the master.
• Connect the slave 2 monitor outputs 1 to 16 to camera inputs 17 to 32
respectively on the master.
• Connect the slave 3 monitor outputs 1 to 16 to camera inputs 33 to 48
respectively on the master.
The outputs from the slaves must be connected in numeric order so that
they have a one to one correspondence with the inputs on the master, do
not change the numeric sequence.