Operating instructions

The caption should now be displaying the model number and
software version.
Use <1> to move the caption up and <2> to move it down.
Press <4> and the display changes to the software date.
Use <1> to move the caption left and <2> to move it right.
Release <AUTO>.
To display the software version ... follow the instructions for
positioning a caption on the screen (above.)
ToRESETyourDVS2tofactorydefaults ... Remove the power
plug from the back of your DVS2. Press and hold <AUTO> and
<SPOT> re-insert the power plug, wait for 3 seconds then release
<AUTO> and <SPOT>.
Using the DVS2 with Alarms
The AL8 has 8 alarm inputs, its function is to tell the DVS2 which
of the alarms are active. The DVS2 assumes that
alarm 1 = camera 1, alarm 2 = camera 2 and so on. When only
one alarm is active the DVS2 shows the alarmed-camera on the
main monitor. If two or more alarms are active it can either:
• onlydisplay the most recent alarmedcamera or,
• introducethe alarmedcamera into a special sequence with a2
second dwell-time.
Then, once the alarms are all cleared it can either:
• hold the last alarmedcamera on the main monitor,
• start the normalsequence on the main monitor or,
• returnto the settingsit hadbefore the first alarm.
A flashing LED indicates that the corresponding alarm is active
or has been active. Press the numbered key to cancel this once the
alarm is cleared.
English Page 7