Operating instructions

Connecting your DVS2

Make all the video connections using 75ohm coaxial cable with

BNC connectors on each end.

When you are ready to connect your DVS2, refer to figure 2 and

follow the instructions given below:-

» Connect a cable from the connector labelled MAIN to your monitor

or VCR.

» Connect cables from the cameras to the numbered video-input

BNCs.

» Plug the jack-plug from the 12V DC power supply into the

jack-socket marked 12V DC.

» Plug the power supply into a suitable mains power outlet.

» Switch on the cameras, monitor and DVS2 (at the mains power

outlet).

Note: We have provided a supplementary earth terminal on the

rear panel, please ask Baxall Technical Support if you need

further information.

Switching On the Power

When you switch the power on, your DVS2 may start by

displaying a sequence or a single camera. If it cannot find any

camera inputs then it scans rapidly through the camera selection

LEDs but does not display a picture.

MAIN

SPOT ALARM

12V

Earth Terminal

Figure 2. Rear Panel Connections

English

Page 5