Operating instructions

Connecting your DVS
Make all the video connections using 75ohm coaxial cable with
BNC connectors on each end.
When you are ready to connect the switcher, refer to figure 2 and
follow the instructions given below.
» Connect a cable from the connector labelled MAIN to your monitor
or VCR.
» Connect cables from the cameras to the numbered video-input
BNCs.
» Plug the jack-plug from the 12V DC power supply into the
jack-socket marked 12V DC.
» Plug the power supply into a suitable mains power outlet.
» Switch on the cameras, monitor and switcher (at the mains power
outlet).
Note: We have provided a supplementary earth terminal on the
rear panel, please ask Baxall Technical Support if you need
further information.
Switching On the Power
When the power is switched on the switcher may start by
displaying a sequence or a single camera. If it cannot find any
camera inputs then it scans rapidly through the camera selection
LEDs but does not display a picture.
Figure 2. Rear Panel Connections
English Page 5