Download

ManualsBrandsBaumr-AG ManualsGarden Power ToolsBaumr-AG 65CC Long Reach Pole Chainsaw Hedge Trimmer Pruner Chain Saw Tree Multi Tool

Petrol Powered Pole Tools

For grass cutting "fixed line" head:

a. Place the grass cutting head coupler (I) over

the drive shaft – it must locate centrally to the

to the raised section of the drive washer (A).

b. Place the washer (J) (supplied with the fixed

line grass cutting head) over the drive shaft,

then secure the assembly with the nut (F).

The thread on the drive shaft is "left-hand".

This means that you must rotate the nut to

the left (anti-clockwise) to screw it on as

shown by the yellow arrow. Firmly tighten the

nut using the supplied spanner. To prevent

the drive shaft from rotating as you tighten

the nut, insert a suitable object (G) (Allen key,

screwdriver etc) through the hole in the

attachment head and into the hole in the drive

washer when tightening – you may need to

rotate the drive washer until the holes are

aligned.

c. Screw the grass cutting head (K) in to the

coupler. The thread on the coupler is "left-

hand". This means that you must rotate the

grass cutting head to the left (anti-clockwise)

to screw it in as shown by the yellow arrow.

Firmly tighten the grass cutting head by hand.

To prevent the drive shaft from rotating as

you tighten the grass cutting head, insert a suitable object (G) (Allen key, screwdriver etc)

through the hole in the attachment head and into the hole in the drive washer when tightening –

you may need to rotate the drive washer until the holes are aligned. Remove the object when the

grass cutting head is secured.

Loading the Grass Cutting "Bump" Head

Do NOT attach or detach cutting tools when the engine is

running. • Ensure that parts are cool enough to touch

before attaching or detaching cutting tools. • Do NOT use cutting

equipment that is cracked, bent, chipped or damaged in any way. Replace

damaged parts. • Use 1.6 to 3mm (1/16 to 1/8") plastic cutting line only. Non-plastic cutting line may not

function properly and may damage the machine.

• If the grass cutting head is dirty, clean it.

To load the grass cutting bump head with cutting line:

1. Remove the grass cutting head from the drive shaft. The thread on the drive shaft is "left-hand". This

means that you must rotate the grass cutting head to the right (clockwise) to unscrew it. To prevent the

drive shaft from rotating as you loosen the grass cutting head, see here

2. Place the grass cutting head (A) on a solid surface, then press down and rotate the "bumper" (B) to the

right (clockwise) until the cutting line holes are aligned (X) and you can see through the head.

Note: If there is remaining cutting line in the head, press down and rotate the "bumper" to the left (anti-

clockwise) one step, then pull the cutting line out from either side of the head. Repeat until you can pull the

line out completely from the grass cutting head.

3. Insert the new line (C) through the grass cutting head so that the lengths of line on each side of the head

are the same (in other words, the head is at the centre of the length of cutting line).

4. Hold the grass cutting head firmly, then rotate the "bumper" to the right (clockwise) to wind in the cutting

line. Stop winding when there is approximately 50mm (2") of cutting line outside of the head.

5. Install the grass cutting head

Video Tutorial:

Loading a Grass Cutting

"Bump" Head

BAUMR-AG BAUMR-AG BAUMR-AG BAUMR-AG BAUMR-AG BAUMR-AG BAUMR-AG BAUMR-AG BAUMR-AG BAUMR-AG BAUMR-AG