BaumCut 26.
These side table instructions shows assembling (1) side table and the parts required. A complete kit contains parts for (2) side tables. Instructions in this manual are for both sides. Assemble the (2) legs as shown. Ball end of threaded rod is for triangular foot. Include jam nut for final leveling position. Remove the existing RH and LH end plates on the existing cutter table. Note that the setscrews shown are to be installed. The parts shown are for (1) side table.
Install (2) black plastic threaded inserts into the large holes from the inside of the table. These are for the back plate that will be mounted later. Align side table with mounting bracket as shown. Locate the mounting brackets and hardware shown at the right. Align side table as shown with existing cutter table. Assemble mounting brackets to table as shown Level table using straight edge Adjust the height by turning leg adjustment screws to make table level.
Install back plate on side table using parts shown. Install the plastic arm shield guards that mount underneath the existing infrared light beams. This is a mandatory safety requirement! This piece prevents the operator from being able to reach in from the side and come in contact with the clamp and knife. Peel off the protective film covering on the part before installing. Use the hardware shown. Note that there is to be (2) square nuts and (2) screws for each arm shield.
Baumfolder Corporation 1660 Campbell Rd. Sidney, OH 45365 1-800-543-6107 www.baumfolder.com baumfolder@baumfolder.
