Instruction Manual

1.0 Technical Data/Machine Layout/Transport and Installation of the Machine/Safety Relevant Machine Elements
Technical Data
Cutting width 67 cm / 26,38" Voltage supply (3 phase) 200 - 240, 50/60Hz
Clamp opening 8 cm / 3,15" Fusing 3 x 25A
Feed depth 67 cm / 26,38" Voltage supply (3 phase) 360 - 420V, 50/60Hz
Power requirement (main motor):
Single phase A C
3 phase
Net weight
Width
2,2 kW / 3,1 H.P.
2,4 kW / 3,4 H.P.
620 kg / 1367 lbs
125 cm / 49,2"
Fusing 3 x 16A
Voltage supply single phase AC (200 - 240, 50Hz)
Fusing 1 x 32A
Length 182,5 cm / 71,85" Voltage supply single phase AC (210 - 240, 60Hz)
Height 151,5 cm / 59,64" Fusing 1 x 32A
Front table length
Table height
Clamp pressure, min.
max.
67 cm / 26,38"
90 cm / 35,43"
200 daN / 440 lbs
1500 daN / 3300 lbs
Attention!
The wire cross section of the main power supply according to the coun-
trys regulations.
Same regulations according the plug connectors.
Knife thickness
Grinding reserve, max.
Smallest cut
without false clamp, min.
with false clamp, min.
9,7 mm / 0,38"
2,2 cm / 0,86"
1,5 cm / 0,6"
5,5 cm / 2,16"
Noise emission
Noise level measurement according to EN 13023, L
pA
(dB):76,5
Extraneous and room noise correction has been carried out.
Backgauge speed 0 - 7 cm/sek.
Knife speed/min. 20
daN = kp
K1 - 11