BAUM BAUM 2020 SOUND COVER INSTALLATION ©Baumfolder Corp., 2006 Printed in U.S.
© 2006 BAUMFOLDER CORPORATION All Rights Reserved WARNING • Do not operate this machine without all guarding in place. • Do not make adjustments or perform maintenance on this machine with power on. • Keep the machine and the work area clean and free of spills to prevent accidents. • Be sure to replace any safety decals that may have been detached for any reason.
Figure 2 Figure 1 FK2001581 Assemble the sound cover mounting assemblies as shown in figures 1 & 2 above.
Figure 4 Figure 3 Mount one sound cover mounting assembly to the right hand frame between gapsets #1 and #3 using the empty taped hole shown in Figure 3. The bracket assembly should be installed on the inside of the frame as shown in Figure 4. Use (1) 262-493-01-00 socket head cap screw (M10 x 16) for mounting the bracket assembly. Then mount the second assembly to the left hand side frame between gapsets #1 and #3 using the empty taped hole.
Figure 6 Slide the bottom plate in until it stops as shown in Figure 6. No fasteners or adjustments are required. Figure 7 Install the upper sound cover assembly by sliding mounting collars over the stub shafts on the mounting bracket assemblies as shown in Figure 7. Lower cover until it rests on bottom plate assembly. No fasteners or adjustments are required.
