Service Manual
I-FOLD ELECTRICAL INSTALLATION
1. WARNING: Power MUST BE DISCONNECTED from the machine before starting this procedure.
2. Remove the back feeder, parallel & register guards.
3. Install I-fold display mount (See Assy. Drawing FK2001426) onto register frame as shown in I-fold display mounting
location (See Page 33). Note: Before tightening the (4) socket head screws, locate display mount so that a gap
between the top of the register frame and the display mount is at maximum clearance, so that the register guard
can be re-installed.
Figure 1
COM 6 Power Switch Power Socket
1