Service Manual

This should be set from the factory.
0 = Autoset
1 = 2015
2 = 2020 pile
3 = 2020 continuous
4 = 1526 or 1530
Once the number of plates in the Parallel
are set these boxes will disappear. Verify
the settings are correct before setting the
number of plates in the parallel.
This will only appear if the machine type is
4. It should be set from the factory to the
width of your machine.
Touch this box to tell Ifold how many plates
you have in the parallel unit. It will
increment thru 0 2 3 4 6 each time you touch
this box.
Touch this box to tell Ifold how many plates you
have in the 8page unit. It will increment thru 0 2
3 4 6 each time you touch this box. If you do not
have an 8page unit leave it set to 0
Touch this box to tell Ifold how many plates you
have in the 16page unit. It will increment thru 0
2 3 4 6 each time you touch this box. If you do
not have a 16page unit leave it set to 0
Once you have completed the configuration
touch this button to go to the main page.
Page 14 of 45
TP10497