Owner manual

These areas show the number of sheets that go under each gapset and the fold plate settings for every
station required to do the selected fold. The black boxes indicate the gapset and fold plate numbers,
the dark blue boxes indicate the number of sheets that go under the corresponding gapset and the light
blue or gray boxes indicate the fold plate setting. Example: On the parallel station gapset number 1
needs 1 sheet of paper and fold plate number 1 is set to 8 ½ inches to do the selected fold. Touch
anywhere in each area and it will take you to the corresponding adjustment screen, from that screen
you can make any changes needed to the number of sheets in the gapsets or the fold plate settings.
This area shows the current fold selected and if it
is saved what name it is saved under. Touch the
blue box under the fold saved name to go to the
save job screen.
Touch this button to see
the setup list. The setup
list is explained on page 4.
This area shows the suggested scoring dies for each station to run the selected fold.
This area shows the feeder settings. Where to set the non-operator side paper guide and the blow tube settings.
TP10509
Page 9 of 29