User guide

TP10386 © Page 4 of 12
The Easy-Mode is used for folds that require half of the sheet length or less
going into the foldplate. These folding applications normally operate with a 1.0
Inch sheet gap. If you are folding half of the sheet length or more into the
foldplate you must have a greater gap.
TURN THE EASY-PARAMETER ON/OFF
1. Press the Machine Setup button found in the top row.
2. Press the Sheet Gap
+ or – Buttons until P20 appears in the sheet gap display.
3. Press the Batch Count + Button until P25 appears in the
sheet gap display. You will now see the word “EASY” in the counter display, see
Figure E1.
Figure E1.