BAUMFOLDER CORPORATION Quality Bindery Equipment Since 1917 2020 KICKER ASSEMBLY INSTALLATION INSTRUCTIONS ©Baumfolder Corp., 2000 Printed in U.S.
© 2000 Baumfolder Corporation All Rights Reserved WARNING Do not operate this machine without all guarding in place. Do not make adjustments or perform maintenance on this machine with power on. Keep the machine and the work area clean and free of spills to prevent accidents. Be sure to replace any safety decals that may have been detached for any reason.
CONTENTS 1.0 KIT INSTALLATION ............................................................................................................... 4 2.0 KICKER FUNCTION SETUP ................................................................................................. 7 3.0 PARTS ...................................................................................................................................... 12 4.0 SCHEMATIC ................................................................................
1.0 KIT INSTALLATION Note: This Feature is applicable only on Folders with the DCT500 Controller Installed. CAUTION ELECTRICAL SHOCK HAZARD PRESENT. THIS KIT SHOULD ONLY BE INSTALLED BY QUALFIED PERSONNEL. Remove electrical power from the folder at the main circuit breaker panel. This will ensure that the installer will not come into contact with the main power leads at the folder disconnect switch.
Install the kicker module, A20(Figure 4-1), on the DIN rail in the upper left corner of the main electrical enclosure, as shown. Place the two cable tie anchors in the approximate location show in Figure 4-2. Remove the protective plexiglass cover(Figure 5-1) that covers the main circuit board. Also remove the two wireway covers(Figure 5-2). Install the wires from the kicker module, A20, per the wiring instructions of Figure 6. After installation of wires, replace plexiglass cover and two wireway covers.
CKT NO.
17 8 12 10 14 24 2 25 28 1 29 + 5 4 30 32 33 + + 6 0 h 7 3 8 2 9 1 31 + 10 BAUMFOLDER CORPORATION 36 9 13 11 16 15 26 27 3 22 18 23 19 4 20 5 21 7 34 6 35 Change Batching Type 2.0 KICKER FUNCTION SETUP + 2.1 Select Count Source The Output Count and Input Count keys select between count at delivery and feeder, respectively. One key LED will always be lit in Counter Setup to show the current count source, see below.
Batching Time Adjustment + The batching time adjustments allow the user to select the time duration associated with the currently selected output type. Two output types and times are available. 1. Feed interrupt has a range of 0.0 to 9.9 seconds. 2. Speed-up Table has a range of 0.00 to 5.00 seconds. Set the range at approximately 0.5. 2.3 Make Ready Mode This key places the controller in the make ready mode. The key LED goes on.
PAGE 9 TP10324A BAUMFOLDER CORPORATION UNIT NAME: DESCRIPTION: 2020 KICKER KIT 2020 KICKER MODULE ASSEMBLY TP268-090-BG-01 ASSEMBLY NUMBER: SHEET 1 OF 2 REV:
TP10324A PAGE 10 DESCRIPTION: BAUMFOLDER CORPORATION UNIT NAME: 2020 KICKER MODULE ASSEMBLY 2020 KICKER KIT ASSEMBLY NUMBER: TP268-090-BG-01 REV: SHEET 2 OF 2
PAGE 11 TP10324A BAUMFOLDER CORPORATION UNIT NAME: DESCRIPTION: 2020 KICKER KIT 2020 KICKER DEVICE ASSEMBLY ASSEMBLY NUMBER: TP220-889-02-00 SHEET 1 OF 1 REV:
TP10324A PAGE 12 DESCRIPTION: BAUMFOLDER CORPORATION UNIT NAME: 2020 KICKER KIT ASSEMBLY 2020 KICKER KIT ASSEMBLY NUMBER: 268-090-BG-01 REV: SHEET 1 OF 2
PAGE 13 TP10324A BAUMFOLDER CORPORATION UNIT NAME: DESCRIPTION: 2020 KICKER KIT 2020 KICKER KIT ASSEMBLY ASSEMBLY NUMBER: 268-090-BG-01 SHEET 2 OF 2 REV:
TP10324A PAGE 14 DESCRIPTION: BAUMFOLDER CORPORATION UNIT NAME: 2020 KICKER KIT SCHEMATIC 2020 KICKER KIT ASSEMBLY NUMBER: 267-385-00-11 REV: SHEET 1 OF 1
Baumfolder has authorized dealers located throughout the United States. Call toll free, 1-800/543-6107 for parts or the number of your nearest authorized dealer. BAUMFOLDER CORPORATION Quality Bindery Equipment Since 1917 1660 Campbell Road Sidney, Ohio 45365-0728 Phone: 937/492-1281 or 800/543-6107 Fax: 800/452-0947 Internet: www.baumfolder.com E-mail: baum@bright.
