User Manual

PAGE 13 TP10313-1
2.1.1 Machine Setup Parameters
Table 1. Machine Setup Parameter List
P00: Input Factor
Each sheet sensed by the Sheet count sensor is multi-
plied by the Factor number and added to theTotal Input
Count, but does not effect the Batch Down Count, Number
of Batches or the Rate. The Factor can range from 1 to 24. If
the Input Factor is changed, it also changes the value of the
Output Factor to the same setting.
P01: Output Factor
This number is added to the Total Output Count but
does not effect the Batch Down Count, Number of Batches
and the Rate. The Factor can range from 1 to Input Factor
setting.
2.1.2 Machine Monitor Parameters
Table 2. Machine Monitor Parameter List
P10: Machine Speed (Velocity)
This selection shows the machine speed in meters/
minute.
P11: Job Run Time
Displays the time duration this job has ran. Time
displayed in .01 Hours. This information becomes part of the
job record.
P12: Job Stop Time
Display the time duration this job has been interrupted.
Time displayed in .01 Hours. This information becomes part
of the job record.
P13: Job Make Ready Time
Displays the length of time that the Make Ready
feature was enabled. Time displayed in .01 Hours. This
information becomes part of the job record.
Parameter Function Type Variable Displayed
P00 Input Factor Setup Variables Adjustable 1-24
P01 Output Factor Setup Variables Adjustable 1 to Input Factor
P02 Tremat Setup Variables Adjustable 1 or 0
P03 Knife Setup Variables Adjustable 1 or 0
P02: Tremat
This is an unavailable option.
P03: Knife
This is an unavailable option.
# Function Type Variable Displayed
P10 Machine Speed Process Variable Based on input Meters/Minute
P11 Job Run Time Process Variable Based on input Hours
P12 Job Stop Time Process Variable Based on input Hours
P13 Job Make Ready Time Process Variable Based on input Hours
P14 Pause Time Process Variable Based on input Hours
P15 Job Number Process Variable Based on Input Number 1 - 9999
P16 Employee’s Number Process Variable Based on input 1 - 255
P14: Pause Time
Display the length of time that the Job was Paused.
Time displayed in .01 Hours. This information becomes part
of the job record.
P15: Job Number
A Job Number may be entered so that production
data may be recorded against it. This is an operator entry.
This information becomes part of the job record.
P16: Employee’s Number
An Employee may be assigned a number. When
the employee operates the machine, his number may be
entered. This information becomes part of the job record.