Instruction Manual

9"
"
As"you"place"each"strip"of"paper"into"the"proper"fold"rolls"that"you"are"setting"the"gapsets"for,"it"
is"helpful"t o "tu rn "th e "g ap s et "kn o b "co u n te rHclockwise"until"the"strip"of"paper"is"being"held"lightly"
by"the"fold"rolls.""
H While"placing"the"strip"of"pap er"on "the "ope rato r"side"o f"the"fo ld"rolls,"adjus t"the"#1 "
gapset"knob"on"the"operator"side."
H While"placing"the"strip"of"paper"on"the"nonHoperator"side"of"the"fold"rolls,"adjust"the"#1"
gapset"knob"on"the"nonHoperator"side."
"
"
"
4. Calibrating"the"fold"roll"gap/pre ssure .""
Note:&The&proper&factory&calibration&of&the&gapsets&is&to&where&by&individually&pulling&on&each&
strip&of&paper&and&the&fold&rolls&just&starting&to&rotate.&&&
Not&enough&fold&roll&pressure&could&cause&the&folds&to&be&tight&and&not&provide&enough&
drive&for&the&sheets&to&flow&through&the&roll&bank.&
Too&much&fold&roll&pressure&can&cause&unnecessary&cracking,&especially&on&coated&
stocks,&and&could&cause&premature&w ear&of&the&fold&rolls.&
"
a) To"do"this,"gently"pull"on"the"strip"of"paper"on"the"operator"side"and"feel"the"
amount"of"pressure"the"fold"rolls"are"applying."
"
o "If"pullin g"o n "t h is"s tr ip "o f"p a p er "fe lls"lik e "th e re "is"n o t "enough"p re s su r e"a n d "d o e s "
not"cause"the"fold"rolls"to"start"rotating,"turn"the"gapset"knob"counterHclock"
wise"to"add"more "fold"ro ll"pressu re."
"
o If"pulling"on"this"strip "o f "p ap e r "fells "lik e"t h er e"is "to o "much"pr e ss u re "and"cause "
the"strip"of"paper"to "tear"rota ting,"turn "the "gap set"kn ob "clock "wise "to"red uce "the "
amount"of"fold"roll"pressure."
"