Instruction Manual

8"
"
Recalibrating"Fold"Roll"Pressures"for"Fold"Roll"Wear:((
!"#$%&'(
)* +%(,-(.$/011$23 $ 3 (%0 (- 4 5 %(,2 / 0 1,26(708$.(0##(%0 (%4 $ (# 0 93 $. (: &(5-,26(%4$ (1",2(708$.(
3,-/022$/%(90/"%$3(02(%4$(7"."99$9(52,%(0.(3,-/022$/%,26(708$.(%0(%4$(1"/4,2$(:&(5279566,26(,%(
#.01("2&;" 99((708$.(-05./$<-=*(
(
2. >5$(%0(70--,:9$(,2?5.&@(2$A$.("%%$17%(0.("9908("2&02$(%0("%%$17%(%0(-$%(%4$(#093(.099(6"7-$%-(
84,9$(%4$(#093(.099-(".$(.522,26*"
(
(
"
Adjusting"fold"rolls"due"to"normal"wear"and"tear"on"the"folder"is"commo n."R eca librating"th e"fold "
rolls"for"this"is"very"easy."
1. Remove"plastic"caps"from"the"top"of"all"of"the"gapset"knobs."
"
2. Loosen"the"nuts"in"all"of"the"gapset"knob"cavity"using"a"½”"or"13mm"nut"driver."
"
3. Place"(1)"1”"wide"strip"of"20#"bond"paper"towards"the"outer"portion"of"the"main"and"#1"fold"rolls"
ensuring"that"the"paper"is"making"full"contact"with"the"urethane"bands"of"the"fold"rolls."
Plastic"Binder"Plug"
Set"Screw
Cap"
Gapset"Knob"
Gapset"Setting"Dial"Indicator"w/"Label"
Foldhead"Frame "
Fold"Roll"
Ela stic"Stop"Nut"
Gapset"Rod/Block"
Weldment"