Instruction Manual

7"
"
8. While"holding"the"gapset"knob"so"it"does"not"turn,"tighten"the"elastic"stop"nut"located"in"th e "
cavity"of"the"gapset"knobs"slowly"to"ensure"that"it"just"contacts"the"gapset"knob."This"is"done"
using"a"1/2”"or"13mm"nut"driver."Do"this"for"all"gapset"knobs."
"
">0(20%(%0.D5$(%4,-(25%(02%0(%4$(6"7-$ %(E20:N(029&(%,64%$2 (%4,-(25 %(52%,9(,%(?5-%(%05/4$-(%4$(
6"7-$%(E20:M(
(
(
(
These"nuts"on"top"of"the"gapset"knobs"serve"2"purposes:"
"
a) With"the"nuts"just"tightened"until"they"are"just"touching"the"gapset"knobs"while"
the"gapset"is"set"in"betw e en "1"&"15,"the"operator"can"now"adjust"the"fold"roll"
pressures"for"running"a"thinner"stock"than"20#"bond"such"as"Bible"paper,"etc."
"
b) If"the"op e ra to r"is "a b le"t o "se t"t h e "ga p s et s"t o "a"g a p se t "se tting"greater "th a n "1 5 ,"th e "
operator"can"just"turn"the"gapset"knob"counterHclockwise"until"it"contacts"this"
nut."The"operator"can"then"turn"the"knob"clockwise"until"a"gapset"setting"of"1."
The"fold"roll"pressure"for"this"roll"should"now"be"set"for"a"single"sheet"of"20#"
bond"paper."
(
9. Turn"all"of"the"gapset"knobs"back"to"1."It"is"recommended"that"you"check"the"fold"roll"pressures"
of"all"fold"rolls"by"using"1”"wide"strips"of"20#"bond"paper"ad"doing"the"pull"test."IF"the"fold"roll"
pressures"remained"the"same"with"all"gapset"knobs"set"at"1,"then"you"may"proceed"to"the"next"
step."If"the"fold"roll"pressures"do"no t"fee l"correc t,"it"will"be"ne ce ssa ry"to"rep ea t"step s"4"H"6"to"
properly"set"the"fold"roll"pressures.""
"
10. The"gapset"knob"caps"can"now"be"pressed"into"the"top"of"the"gapset"knobs."
"
11. The"gapset"calibration"is"now"complete."
"
"