Owner manual

TP10476-1 PAGE 36
6.3 Machine Run Error Messages
Machine Run Error Messages help the operator to indicate a production problem.
English German Codes TYPE DESCRIPTION
Stop Stop1 Stop1 Information One of the stop buttons is depressed.
ACTION: Make sure all stop buttons are cleared and
connectors X21, and X22 are seated.
Jam Fehlerbg Stop2 Operating The Wrong Sheet Detector has been tripped.
Error ACTION: Clear the fault. NOTE: If the
main drive was running the error condition will remain latched
until the Drive START is pressed.
2 Sheet Doppelbg Stop3 Operating The Double Sheet Detector has been tripped.
Error ACTION:Clear the fault and check X22. NOTE:If sheet feed
was active the error condition will remain latched until the
Sheet Start is pressed.
No Feed Bog. Fehl Stop4 Operating No paper detected within 40 cm of suction valve
Error actuation, while running in an automatic feed mode.
ACTION: Check misfeed, connector X14, and the condition of
the count eye.
Feeder Sensor Stop5 Operating Photoeye at suction valve is covered before sheet start is active.
Error
Long Sht Bg. Lang Stop6 Operating The count eye has been covered for more than 150% of the
Error user set sheet length distance.
ACTION: Check misfeed, connector X14, and the condition of
the count eye.
S -C 1 B - C 1 Stop7 Operating Sheet monitor at Knife 1 activated. Folding problem. Re-learn
Error sheet if necessary, or check light sensor.
S -C 2 B - C 2 Stop 8 Operating Sheet monitor at Knife 2 activated. Folding problem. Check
Error 1 x 4 connector and light sensor if necessary.
.
S - C 4 B - C 4 Stop 9 Operating Sheet monitor at Folding station 1 activated
Error
Snsor DN Stpl Ab Stop 10 Operating The Pile has been moving down for more than 2.5 seconds
Error while the unit is feeding paper.
ACTION: Check Pile Sensor.
Snsor Up Stpl Auf Stop 11 Operating The Pile has been moving up for more than 1.5 seconds
Error while the unit is feeding paper.
ACTION: Check Pile Sensor.