Owner manual

PAGE 25 TP10476-1
P42: Folding station delivery
Display of the time registered by the photoelectric barrier on the folding station delivery.
P43:Counting input
Display of the time registered by the photoelectric barrier on the counting input.
Important:
The counting input is not monitored when Kicker batching is selected.
If the counting input is removed when the machine is activated, error message S-C 5 /B-C 5/STOP 13 is
displayed once and the drive is shut down. The error message is cancelled when the machine and the sheet feed
are restarted. The machine is reactivated by the rear edge at the counting input.
P44: Knife 1 strokes
Select this parameter to view the total number of strokes (in 1000s) for Knife 1.
P45: Knife 2 strokes
Select this parameter to view the total number of strokes (in 1000s) for Knife 2.
# Function Type Variable Displayed
P50 Main time switch ON Machine status Main switch ON Time in hours (decimals)
P51 Machine operating time Machine status Drive Start Time in hours (decimals)
P52 Total sheet feed Machine status Input X14/4, P31.1 Display x 1000 sheets
P50: Main time switch ON
Can only be reset in Service mode.
P51:Machine operating time
Can only be reset in Service mode.
P52:Total sheet feed
Select to view the total number of sheets fed in (in 1000s).
The total is reset to zero when new operating data is entered.
Exit Machine Setup Mode
Pressing any of these keys will cause the controller to change to a new mode.
h
0
Table 7 Machine operating statistics