BAUMFOLDER 714XLT SOUND COVER INSTALLATION © 1999 Printed in U.S.A.
© 1999 BAUMFOLDER CORPORATION All Rights Reserved WARNING • Do not operate this machine without all guarding in place. • Do not make adjustments or perform maintenance on this machine with power on. • Keep the machine and the work area clean and free of spills to prevent accidents. • Be sure to replace any safety decals that may have been detached for any reason.
1.0 SOUND COVER INSTALLATION INSTRUCTIONS 1) Getting Started Its very important that you follow these instructions in the sequence noted. Read the instructions carefully before proceeding with the actual work. WARNING Make certain that the 714XLT is unplugged. Do not plug the power cord into an AC outlet until the XLT is fully re-assembled, adjusted and ready to use. Unplug the XLT any time disassembly is required.
5) Remove the the operator handwheel using an allen wrench to loosen the set screw. Set the handwheel aside for re-installation. 15) Your sound cover guard installation is now complete. 6) Using an allen wrench, remove the operators side guard by removing the four button head screws that attach the guard to the frame. The guard on the operators side contains the folder drive motor and counter wires which should be marked if they are going to be removed.
1 2 3 5 4 6 7 PAGE 5 8 4 10 TP10302A Figure 3 7 9
TP10302A 1 2 3 4 5 5 PAGE 6 3 2 Figure 4
Baumfolder has authorized dealers located throughout the United States. Call toll free, 1-800/543-6107 for parts or the number of your nearest authorized dealer. BAUMFOLDER CORPORATION Quality Bindery Equipment Since 1917 1660 Campbell Road Sidney, Ohio 45365-0728 Phone: 937/492-1281 or 800/543-6107 Fax: 800/452-0947 Internet: www.baumfolder.com E-mail: baum@bright.
