Instruction Manual

Manual_ProCam_V1-10_EN.doc 2/35 Baumer IVO GmbH & Co. KG
10.05.11 Villingen-Schwenningen, Germany
Content
1
Introduction 4
1.1 Product assignment 4
2 General Information 5
2.1 System requirements 5
2.2 Installation 5
2.3 Software version 5
2.4 Information on commissioning 5
3 ProCam Program 6
3.1 Basics 6
3.2 Program procedure 6
3.2.1 Selecting encoder type 7
3.2.2 Encoder connected to PC - "Automatic selection" 8
3.2.3 Selecting encoder type from table - "Manual selection" 9
3.2.4 Starting encoder programming 10
4 Program Encoder 11
4.1 Menu and icon bar 12
4.1.1 File 12
4.1.2 Settings 13
4.1.3 Extras 14
4.1.4 Info 15
4.1.5 Reprogramming 15
4.1.6 Open file 15
4.1.7 Save file 15
4.1.8 Print 15
4.1.9 Request data from encoder 15
4.1.10 Send data to encoder (save) 15
4.1.11 Display position/activate cam program 15
4.2 "Resolution" programming mask 16
4.2.1 Code (steps) 17
4.2.2 Counting direction 17
4.2.3 Speed scaling 17
4.2.4 Revolutions 18
4.2.5 Steps/revolutions 18
4.2.6 Total resolution 18
4.2.7 Back to main menu 18
4.2.8 Dialog window 18
4.2.9 Display of encoder type 18
4.2.10 Read encoder data 19
4.2.11 Send encoder data 19
4.3 "Outputs" programming mask 20
4.3.1 Output 21
4.3.2 Data Valid 21
4.3.3 Speed 21
4.3.4 Still 21
4.3.5 Run Control 21
4.3.6 Inverted 21