User guide

02.12 – SAP-No.:11085289

Subject to modification in technic and design.

www.baumer.com Errors and omissions excepted.

Installation instruction protective cover HS35

Features

Protective cover for encoder HS35 – matched for motor flange NEMA 56C (4,5“) and fan cover.

For attachment to a fan cover hammer head bolts are recommended (not included).

Scope of delivery

- 1x protective cover HS35

- 1x contact protection clip

- 3x cylinder screw (0.75 inch long)

- 3x flat washer

- 3x lock washer

- 1x protective label

PAGE 1
Installation instruction protective cover HS35 Features Protective cover for encoder HS35 – matched for motor flange NEMA 56C (4,5“) and fan cover. For attachment to a fan cover hammer head bolts are recommended (not included). Scope of delivery - 1x protective cover HS35 1x contact protection clip 3x cylinder screw (0.75 inch long) 3x flat washer 3x lock washer 1x protective label www.baumer.com 02.12 – SAP-No.:11085289 Subject to modification in technic and design. Errors and omissions excepted.
PAGE 2
Mounting protective cover HS35 • The incremental encoder must be slide on to driveshaft by hand. Do not force! If necessary check and verify the driveshaft diameter. • The torque support on mounting side (e.g. motor Bshield) shown in graphic [1] fastening without pressure. Tightening torque max. 1700 oz-in (max. 12 Nm). • The incremental encoder shaft fastening with the clamping ring on the motor shaft. Tightening torque of the clamping ring screw max. 312 oz-in (2.2 Nm).