User Manual

en_BA_U500_UR18_Gen2_IO-Link.docx 32/43 Baumer Electric AG
04.04.2019/ Frauenfeld, Switzerland
between output switching
behaviour and pin
Inverted:Pin high, LED off
On: Pin high, LED on
LED Settings.Blue.Mode
Switches the LED off, no
change of other function
rw
On / Off
Default: On
If the LED mode is set
- On, the behaviour of the related LED is as described in Figure 26.
- Off, the LED is deactived except if the function Find Me is activated. (See section 3.2.2)
- Inverted, the LED behaviour is inverted to the definition in Figure 26.
If the yellow LED is configured to work as alignment aid (only for the .R type), the LED indicates the strength
of the received signal. The faster the flashing, the stronger the signal.
4.8.2 Teach Mode (Local, by wire)
For the local teach, 2 different teach methods are available – Xpert and Xpress.
While the Xpert mode represents the standard teach method with 4 teach levels available, the Xpress mode
allows to simplify the teach-in procedure significantly by reducing it to only one teach level.
Also the number of actions required to teach-in the position is reduced to one single activation of qTeach or
the ext. teach-in.
Parameter name
Short Description
Rights
Unit / Allowed
values
Teach Mode Settings.Local Teach
Mode
Selects the teach mode if
more than one is available.
Teach modes: 0: xPert:
normal method, 1: xPress:
simplified method
rw
xPert static,
xPress static
Default: xPert
4.8.2.1 xPert Mode
Available Teach Levels:
- Level 1: 1-Point Teach (Barriers: Including alginment aid)
- Level 2: Window Teach / Scanning Range
- Level 3: Output Logic of digital output 1 and output 2
- Level 4: Factory reset
For a more detailed description of the teach-in procedure, please refer to the assembly instruction.
4.8.2.2 Xpress Mode
Available Teach Levels:
- Level 1: Simplified 1-Point Teach
Teach-In Procedure:
- Place object at desired switching / reference distance
- Activate qTeach or ext. teach-in wire for >2 sec
o Green and blue LEDs flash 2 Hz
- Teach-In OK: Sensor goes into operating mode
- Teach-In NOK: All LEDs flash 8 Hz for 1 sec