User Manual

en_BA_U500_UR18_Gen2_IO-Link.docx 27/43 Baumer Electric AG
04.04.2019/ Frauenfeld, Switzerland
4.7 Output Settings
4.7.1 Switching Output
Via this parameter it is possible to select the ouput circuit of the physical outputs. If set to PushPull, the
circuit type (change from NPN to PNP) can also be modified by changing the external load according to the
connection diagram, this can be found in the datasheet or in the Assembly Instruction (MAL) of the
resepective article.
Parameter name
Short Description
Rights
Unit / Allowed values
DI/DO Settings.OUT1
Circuit
Select the output function
rw
- PushPull (default)
DI/DO Settings.OUT1
Mode
Select the SSC channel that is
shown on the Pin
rw
- SSC1 (default)
- SSC2
- SSC4
DI/DO Settings.OUT2
Circuit
Select the output function
rw
- PushPull (default)
- PNP
DI/DO Settings.OUT2
Mode
Select the SSC channel that is
shown on the Pin
rw
- SSC1
- SSC2 (default)
- SSC4