User Manual

en_BA_U500_UR18_Gen2_IO-Link.docx 10/43 Baumer Electric AG
04.04.2019/ Frauenfeld, Switzerland
4 Parameter
4.1 System Commands
A factory reset of the sensor activates the default parameters as programmed in the factory. All parameters
changed by the user will be lost. The factory reset can also be triggered via local teach-in (qTeach or wire
teach) directly at the sensor (see assembly instruction for more information) where only the parameters that
are changed via teach-in will be reset.
Parameter name
Short Description
Rights
Unit / Allowed
values
Standard command
Restore Factory Settings
wo
4.2 Measurement Data Channel (MDC)
4.2.1 Measurement Value Distance
Parameter name
Short Description
Rights
Unit / Allowed
values
Measurement Value.
Distance
Process value for distance
ro
mm
4.2.2 Switch Counts
For each individual SSC a switching counter is implemented, which can be used as diagnosis data or also as
measurement value. The number of counts of each channel can also be mapped to the measurement data
channel MDC by adjusting the MDC source. Trigger of counter is on positive slope of related SSC.
Parameter name
Short Description
Rights
Unit / Allowed
values
- SSC1 Switch Counts
Reset
- SSC2 Switch Counts
Reset
- SSC4 Switch Counts
Reset
Command to set the counter value of
the SSC to zero
wo
- Switch Counts.SSC1
Resetable
- Switch Counts.SSC2
Resetable
- Switch Counts.SSC4
Resetable
Total number of switch counts on
SSC1 (resetable by user command->
SSC1 Switch Counts Reset)
Available for SSC1,2 and 4.
ro
32 Bit value