User manual

o Press and hold down the ON/OFF button (19) for 3 seconds.
o The ON/OFF neon (18) will light to confirm that you have switched the
appliance back on again.
Installation
IMPORTANT: Before installation and usage read all the instructions and make sure
that the voltage (V) and the frequency (Hz) indicated on the rating plate are exactly
the same as the voltage and frequency in your home. The rating plate can be found on
the front left edge of the inside of the refrigera
tor.
The manufacturer declines all responsibility in the event of the installer failing to observe all the accident prevention
regulations in force, which are necessary for normal use and the regular operation of the electric system.
Electrical connection
YOUR FRIDGE FREEZER IS INTENDED FOR FITTED AND PERMANENT INSTALLATION.
We recommend that the appliance is connected by a qualified electrician, who is a member of the
N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations.
o Your refrigerator comes supplied with a 13 amp plug fitted. If in future you need to change the fuse in this
plug, then a 13 amp ASTA approved (BS 1362) fuse must be used.
The wiring in the mains lead is coloured as follows:
Brown- Live
Blue- Neutral
Green and yellow- Earth
o As the colours of the wires in the appliance’s mains lead may not correspond with the coloured markings
identifying the terminals in your spur box, please proceed as follows:
The brown wire must be connected to the terminal marked “L” (live), or coloured red
.
The blue wire must be connected to the terminal marked “N” (neutral), or coloured black.
The green and yellow wire must be connected to the terminal marked “E” (earth), or by the earth symbol,
or coloured green and yellow.
o When the connection is completed, no stray strands or cut wire should be present. The cord clamp must be
secured over the outer sheath.
18