User manual

to recirculation mode, then you

should now fit the two carbon filters. See the “Fitting the carbon

pliance should now be connected to the

electrical supply. See page 17 for detailed information on the

the appliance is

operating correctly by selecting each speed and

switching the light bulbs on and off.

Extraction mode or recirculation mode?

Completing the installation

o If you are setting the appliance

filters” section on pages 14-16.

o The electrical connection must correspond to the electrical

requirement noted on the rating plate, which is placed inside the

cooker hood. The ap

ele

ctrical connection.

o Refit the grease filter and then switch on the mains

supply to the appliance. Check that

ING YOUR COOKER HOOD WHETHER TO USE

IN EXTRACTION MODE OR RECIRCULATION

hat is the difference between extraction and recirculation

extraction mode, the stale air will be taken via the grease filter and

via the grease filter, and passed

rough a charcoal filter for purification. The air then re-enters the

or optimum performance, we recommend that the cooke

r hood is

rtunately if you live in a flat or the hood is too far from an outside

all, this may not be possible. The only alternative is to recirculate the

ir.

IMPORTANT: YO

U WILL HAVE TO DECIDE BEFORE

INSTALL

MODE.

modes?

out of the room via external ducting.

In recirculation mode stale air is taken

kitchen via an opening in the hood.

used in extraction mode and connected to external ducting.

Unfo