User manual

20
) Lift the cooker hood fully into the cut out that you made in step 2.
e pre-drilled holes in
the outer frame of the hood, into the kitchen unit. Then replace
using the 2 screws (4 screws for
CAN52.4ME) (B) and reattach the 2 lights.
o Refit the grease filter.
utlet should have a cross section of at least 150
cm² (please note that the ducting hose is not supplied with the
tance between the coupling and your discharge
outlet should be 3 metres, with one 90 degree bend. For each
Before fixing the cooker hood into the kitchen unit, you should
the ducting hose to the coupling in the
top of the cooker hood.
IMPORTANT: Do not connect the electrical cable to the mains supply
at this stage.
5
If you are connecting the cooker hood to external ducting, then secure
the ducting hose to the coupling on the appliance.
o One person should support the hood. The other person should
fully tighten the support screws through th
the extractor frame
Connecting to external ducting
o Connect the coupling to the top of the cooker hood, using two of
the smaller screws provided.
o Connect a Ø125 mm ducting hose to a discharge outlet that is
suitable for cooking vapours.
o The discharge o
appliance but one can be obtained from the Baumatic Spares
Department).
o The maximum dis
additional 90 degree bend, the maximum distance is reduced by
a further metre.
o
connect the other end of