User manual

19
en unit; the cut-
ut must be of the dimensions shown in the drawing below.
CAN52.4ME
2) Create an opening in the underneath of the kitch
o
CAN75.3SS
o IMPORTANT: If you are going to connect your cooker hood to
external ducting, then you must complete the steps listed in the
“Connecting to external ducting” section before carrying on with
or frame (B) to the hood and unscrew the 2 lights.
nsure that the two support clips on either side of the hood are set to
ker hood towards the cut-out that you made in step 2.
eed the electrical cable through the hole that you made in step 3.
the rest of the installation (this information can be found on
page 20).
3) Make a hole in the inside of the kitchen unit for the electrical cable
to feed through. Remove the 2 screws (4 screws for CAN52.4ME)
securing the extract
E
accommodate the thickness of the mounting surface, by adjusting the
clip via the screw.
4) Lift the coo
F