Operation Manual

23
The washer dryer drum
The drum of your washer dryer is constructed from stainless steel.
However if there are objects that can rust placed inside the drum, then
it is possible for the drum to become stained.
IMPORTANT: Do not use a descaling agent, iron/steel wool or
scouring agents to clean the drum of your appliance.
9 Remove any rust stains on the drum with an appropriate
stainless steel cleaning agent.
Door
9 You should regularly check to see if any deposits have
formed, or there are any foreign bodies in the rubber door
gasket. This sits inside the opening of the porthole door.
Error code failure system
If your appliance senses that it is not operating correctly, then an error
code may appear in the LCD display.
Some of the error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING ANY MAINTAINEANCE ON THE
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR MAINS
POWER SUPPLY.
Err1
o Door is not shut properly
9 You should regularly check to see if any deposits have formed, or
there are any foreign bodies in the rubber door gasket. This sits
inside the opening of the porthole door.
Err2
o Drainage error, water has not emptied within 4 minutes.
9 Clean the drain pump filter and check that the outlet hose is not
blocked or kinked.
Err3
o Temperature sensor short circuit or open circuit.
9 Contact the Baumatic Service Department.
Err4
o Heating malfunction
9 Contact the Baumatic Customer Care Department.