Operation Manual

23
Reversing the door of your appliance
Caution! After unscrewing any of the fixing
hinges, hold the door to prevent it from falling
and causing damage.
Any parts that you remove from the appliance whilst
reversing the door, should be retained for later use.
o WHILST SUPPORTING THE DOOR. Unscrew the upper hinge
screws.
o On the bottom side of
the door unscrew the
swing stopper screws
and remove the stopper
(A). Fix the attached
stopper with its bearing
on the opposite side of
the door.
o Unscrew the forced door
closure system (B) and
fix it to the opposite side
of the door (certain
models only).
o Remove the door from the bottom hinge.
o Unscrew the leg holder fixing screws.
o Tilt the appliance backward at a
maximum angle of 35° Unscrew the
leg support screws (C) - left and right,
and remove the leg support cover (D).
Then place it on the opposite side.
Unscrew, remove and then replace
the position of the end switch (E) and
decorative peg (F) (for models with
forced door closing system).
o Unscrew the three screws fixing the
bottom hinge and then fix the bottom
hinge on the opposite side.
o To fit the door on the opposite side of
the freezer proceed with the above procedure in reverse.