Operation Manual

ATTACHING THE GLASS
9 Remove the metal grease filters from
the hood.
9 Slacken both anchoring screws
‘F’ (respectively on the left and
right).
9 Remove the anchoring corner
marked with the letter ‘Z’, pulling
it upwards.
9 Place the glass ‘Q’ on the upper
shelf of the hood, pushing it
towards the wall.
9 Insert the anchoring corner ‘Z’
onto the short side of the unit,
tightening the screws ‘F’ again
in the hole and connecting
them to the unit.
9 NOTE – DO NOT
OVERTIGHTEN THESE
SCREWS – DOING SO MAY
DAMAGE / DISTORT THE
UNIT!
9 Take care that the anchoring corner is
firmly fastened, tightening it well. Re-
insert the metal filters.
16
INSTALLATION INSTRUCTIONS – Attachin
g
the
g
lass