Operation Manual

Your Baumatic Cooker Hood uses CARBON FILTERS to purify the air for the

air recirculation function.

You will find that one filter will attach over the front of the fan motor (please

see figure at bottom of page).

The active carbon filter must be replaced regularly, at least once every four

months, to allow normal operation.

Before starting to fit the carbon filter, turn the omni-polar switch to ‘0’.

Changing the Carbon Filters – Note: carbon filters cannot be cleaned!

1) Remove the metal grease filter grille

BT06.6ME- Single Motor 1 x E1 Carbon Filter

(see page 9), and find the carbon 1 x E

2 Carbon Filter

filter assembly up inside the unit.

BT08.6ME- Twin Motor

2) Remove the old carbon filter by 2 x E2 Carbon Filter

twisting it anticlockwise until it

unlatches from the side of the

motor.

3) Place the new carbon filter (which

has two fixing tongues), turning

clockwise so that the tongues

latch onto the motor’s sides.

(lower right figure on left).

4) Replace the anti-grease

metallic filter grille.

Installing / Changing the Carbon Filter

CARBON FILTER