Operation Manual

a) Changing the LIGHT BULB

9 Disconnect the hood from the power supply.

9 Access the lamp area. Please note that you will have to take off the

grease grille at the back to access the lamp area.

9 Always replace burnt-out bulbs with olive-shaped 40 Watt bulbs.

9 After replacing the bulb, put the grease grille back.

_____________________________________________________________

b) Changing the CARBON FILTER

You will find that one filter will attach over the front of the fan motor (please

see figure at bottom of page).

The active carbon filter must be replaced regularly, at least once every four

months, to allow normal operation when in recirculation mode.

Before starting to fit the carbon filter, turn the omni-polar switch OFF

Changing the Carbon Filter – Note: carbon filters cannot be cleaned!

1) Remove the grease filter grilles.

2) Remove the old carbon filter by

twisting it anticlockwise

until it unlatches from the

side of the fan motor.

3) Place the new carbon filter (which

has two fixing tongues), turning

clockwise so that the tongues

latch onto the motor’s sides. (Fig.

3 - left).

4) Replace the anti-grease

metallic filter grilles.

NOTE

If your filter is different (i.e.

is the Bayonet Circular-

insert type,

Position the filter P in order

to cover the motor

protection grille, ensuring

that the ‘X’ on the filter lines

up with the ‘Y’ on the

conveyor. Then turn

clockwise. Reverse to

dismount

Maintenance – Chan

the Li

ht Bulb and Carbon Filter