BS65MS 60 cm Multifunction Oven
User Manual for your Baumatic BS65MS 60 cm Multifunction oven NOTE: This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference; for you or any person not familiar with the operation of the appliance.
Contents Environmental note 4 Important safety information 5-7 Specifications Product and aperture dimensions Product specifications Standard accessories Electrical details Control panel Oven programmer/timer display 8 - 10 8 8 8 9 10 10 Setting and using the oven programmer/timer Selecting manual operation mode Setting the time of day Before first use Setting the minute minder function Setting the semi-automatic cooking function Setting the end cook function Setting the auto-cooking function Cancelli
Environmental note o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard all packaging material with due regard for the environment.
IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the retailer where you purchased your unit from General Information o This appliance is designed for domestic household use and can be built into a standard kitchen cabinet or housing unit.
Child Safety o Baumatic strongly recommend that babies and young children are prevented from being near to the appliance and not allowed to touch the appliance at any time. o If it is necessary for younger family members to be in the kitchen, please ensure that they are kept under close supervision at all times. General Safety o Do not place heavy objects on the oven door or lean on the oven door when it is open, as this can cause damage to the oven door hinges.
Installation This appliance must be correctly installed by a suitably qualified person, strictly in accordance with the manufacturer’s instructions. o Baumatic Ltd declines any responsibility for injury or damage, to person or property, as a result of improper use or installation of this appliance. o Heat, steam and moisture will be created during use of the appliance, take care to avoid injury and ensure that the room is adequately ventilated.
Specifications Product Dimensions Aperture Dimensions Height: Width: Depth: 580 mm – 583 mm 560 mm 550 mm (min) 590 mm 595 mm 550 mm Product specifications o o o o o o o o o 5 oven functions Energy efficiency class: A Oven gross capacity: 59 litres Oven net capacity: 50 litres LED full programmer Oven light Cooling fan Double-glazed removable door Removable inner door glass Standard accessories o o o o o Safety shelf Enamelled baking tray with handle Trivet Removable side racks BPS2 Pizza stone 8
Electrical details Rated Voltage: Supply Connection: Max Rated Inputs: Mains Supply Lead: Oven Light Bulb: 220-240 Vac 50 Hz 15 A (double pole switched fused outlet with 3mm contact gap) 2.30 kW 3 x 1.5mm² 25 W/300°C screw type pygmy For future reference please record the following information which can be found on the rating plate and the date of purchase which can be found on your sales invoice.
Control Panel 1) 2) 3) 4) 5) 6) Oven function selector knob Thermostat control knob Power indicator light Oven operating light LED display Oven programmer/timer Oven programmer/timer 7) Automatic cooking symbol 8) Oven in use symbol 9) Decimal point symbol 10) Minute minder symbol 11) Plus button 12) Programme button 13) Minus button 10
Initial set-up of your oven Selecting manual operation mode After your appliance is connected to your mains supply for the first time, the numbers on the timer display will flash. Before you can select a cooking function or set a temperature, you must set the appliance into “manual operation” mode. o To select manual operation mode, press the manual button (12) on the control panel.
o You should leave the oven on maximum setting for 30 – 40 minutes. o After the oven cavity has cooled, it should then be cleaned with warm soapy water, using either a sponge or soft cloth. No abrasive cleaners should be used. o Outer parts of the oven should be cleaned with warm soapy water, using either a sponge or soft cloth. No abrasive cleaners should be used. o We would recommend that an appropriate stainless steel cleaner and polish is regularly used on the stainless steel surfaces of this appliance.
of the countdown time. YOU MUST turn the oven function selector knob and the thermostat control knob to their OFF positions. The semi-automatic cooking function This function will allow you to set a countdown time similar to the minute minder function, however the oven will switch off at the end of the cooking time. o Place the food that you want to cook inside of the oven and close the door. o Select an oven function and cooking temperature using the relevant control knobs.
The end of cooking function This function is similar to the semi-automatic function, however instead of setting a countdown time, you select the time of day that you want the oven to switch off at. o Place the food that you want to cook inside of the oven and close the door. o Select an oven function and cooking temperature using the relevant control knobs.
The automatic cooking function This function will allow you to set the time of day that you want the oven to switch off at and how long you want the oven to cook for. o Place the food that you want to cook inside of the oven and close the door. o Select an oven function and cooking temperature using the relevant control knobs. o Press and hold down the programme button (12) until the decimal point starts to flash to enter programming mode, the minute minder symbol (10) will appear on the LED display.
o To reset the oven and cancel the audible alarm, press the programme button until the oven in use symbol appears on the LED display and the automatic cooking symbol goes out. o IMPORTANT: If you have not turned the oven function selector knob and thermostat control knob to their OFF positions, when you reset the oven it will continue to heat.
Changing the time of day o IMPORTANT: The oven timer/programmer must not be in any form of countdown mode and the oven in use symbol (8) must be lit. o Press and hold down the minus (13) and plus (11) buttons simultaneously until the decimal point starts to flash. o Release these buttons and then use the minus and plus buttons to alter the time of day.
FAN AND LOWER ELEMENT: This method of cooking utilises the lower element in conjunction with the fan, which helps to circulate the heat. This function is suitable for sterilizing and preserving jars. CONVENTIONAL OVEN AND FAN: This method of cooking is a conventional cooking method, the oven heat comes from the top element and the bottom element, and the fan helps to circulate the heat to achieve an even baking result.
o You should pre-heat the oven and not place food inside of it until the oven operating light has gone off. o IMPORTANT: You should ALWAYS pre-heat the oven if you are baking. o Make sure that frozen foods are thoroughly thawed before cooking, unless the instructions on the food packaging advise that you can “cook from frozen”. o Before cooking, check that any accessories that are not required are removed from the oven.
Shelf levels o Safety shelf (A) o Removable side racks, which allow you to cook on six different levels (B) o Enamelled tray (C) baking o The numbers 1 – 6, indicate the different shelf positions that you can utilise within the oven. Cleaning and maintenance Cleaning operations must only be carried out when the oven is cool. The appliance should be disconnected from your mains supply before commencing any cleaning process.
o Outer parts of the oven should only be cleaned with warm soapy water, using either a sponge or soft cloth. No abrasive cleaners should be used. o We would recommend that an appropriate stainless steel cleaner and polish is regularly used on the stainless steel surfaces of this appliance. o If you use any form of oven cleaner on your appliance, then you must check with the manufacturer of the cleaner that it is suitable for use on your appliance.
Removing the oven door for cleaning To facilitate the cleaning of the inside of the oven and the outer frame of the oven, the door can be removed as follows:o Open the door fully o The hinges (A) have two movable bolts on them (B). o If you raise both of the movable bolts (B), then the hinges (A) are released from the oven housing. o You should grip the sides of the door at the centre and then incline it slightly towards the oven cavity and then pull the door gently away from the oven cavity.
Removing the inner door glass for cleaning o Do not use any abrasive cleaner that could cause damage. o Remember that if the surface of the glass panel becomes scratched, this could lead to a dangerous failure. o To facilitate cleaning, the inner door glass can be lifted out. o Unscrew the bracket latch that is in the corner of the top of the door. Remove the glass from the door and clean with warm soapy water. o After cleaning, insert the glass panel correctly back into the door.
INSTALLATION The installation must be carried out by a suitably qualified person, in accordance with the current version of the following. o AS/NZS 3000: 2007 Wiring Regulations o 2010 Electricity Safety Regulations Electrical connection Before connecting the appliance, make sure that the supply voltage marked on the rating plate corresponds with your mains supply voltage. WARNING: THIS APPLIANCE MUST BE EARTHED.
Installing the oven into the kitchen cabinet Positioning the appliance o Ensure that the aperture that you will be fitting the oven into is of the size given in the above diagram. o The oven must be fitted into an oven housing with the ventilation cut-outs shown in the “Ventilation requirements” section on the next page. o Ensure that the rear panel of the furniture housing unit has been removed.
Ventilation requirements (Figure shows the ventilation and cut-out requirements for the installation of the appliance into a standard kitchen unit). (Figure shows the ventilation and cut-out requirements for the installation of the appliance into a tall housing unit).
o Ensure that the oven has been securely fixed into the housing unit. The fixing of the oven into the housing is made by using four screws. These should be screwed through the oven cabinet and into the housing unit. My appliance isn’t working correctly o The oven isn’t coming on. * Check that the oven is in manual operation mode. * Check that you have selected a cooking function and a cooking temperature. o There appears to be no power to the oven and grill.
o My food is not cooking properly * Ensure that you are selecting the correct temperature and the correct cooking function for the food that you are cooking. It may be appropriate to adjust your cooking temperature by plus or minus 10°C, to achieve the best cooking results. o My food is not cooking evenly * Check that the oven has been installed correctly and is level. * Check that the correct temperatures and shelf positions are being used.
IMPORTANT: If your appliance appears not to be operating correctly, then you should disconnect it from your mains supply and then contact the Service Department. DO NOT ATTEMPT TO REPAIR THE APPLIANCE YOURSELF. Please note that if an engineer is asked to attend whilst the product is under guarantee and finds that the problem is not the result of an appliance fault, then you may be liable for the cost of the call out charge. The appliance must be accessible for the engineer to perform any necessary repair.
Think Appliances Pty Ltd. 416-424 Barry Rd Coolaroo VIC 3048 Sales Telephone 1300 132 824 Service Telephone 1800 444 357 Website www.thinkappliances.com Applico Ltd. Private Bag 92900 Onehunga, Auckland 1061, New Zealand Website www.baumatic.co.nz United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 6900 Website: www.baumatic.co.
