Operation Manual

169893
marked “E” (earth), or by the earth symbol, or coloured green
and yellow.
• When the connection is completed, no stray strands or cut
wire should be present. The cord clamp must be secured over
the outer sheath.
• It is advisable that your appliance is only installed in a location
where the ambient temperature of the room, corresponds with
the climate classifi cation that is stated on the rating plate of
your appliance. Your appliance may not function correctly if the
ambient temperature falls outside of the following ranges.
Climate classifi cation Appropriate ambient temperature
SN +10 to +32 degrees centigrade
N +16 to +32 degrees centigrade
ST +10 to +38 degrees centigrade
T +18 to +43 degrees centigrade
• Positioning the appliance requires two persons in order to
avoid injuries or damage to the appliance.
• Your appliance should not be located in direct sunlight or
exposed to continuous heat or extremes of temperature (e.g.
next to a radiator or boiler).
• You should check whether there is an electrical socket
available, which will be accessible after your appliance is
installed.
• Place the appliance fl atly and fi rmly on a solid base. The
appliance is fi tted with adjustable feet on the front side, used
to level the appliance.
• The rear side of the appliance is fi tted with wheels which
facilitate the positioning of the appliance into its fi nal location.
• Anything positioned above the appliance must be at least 5
cm away to allow suffi cient cooling of the condenser. You must
allow a 15 mm gap to the rear of the appliance.
• Avoid exposing the appliance to direct sunlight or heat
sources. If this is not feasible, then you should install an
insulation plate between the appliance and the adjacent heat
source.
• The bottom front corners of your appliance are fi tted with
handles to facilitate moving. The appliance may stand
independently or adjacent to a cupboard or wall.
• Be sure to leave enough space for the opening of the door, to
avoid damage to the appliance or personal injury. Also leave
ample space for extracting shelves (see diagram on the next
page).
15
Positioning
169893en.indd 15169893en.indd 15 12.10.2006 11:41:4512.10.2006 11:41:45