User guide

11
Touch control panel user
instructions
CONTROL PANEL ELEMENTS (see fig. 4)
General on/off sensor.
Cursor slider for controlling power.
PLATE SELECTION SENSORS and
power indicators. *
Timer indicators.
Direct access to Power Function.
Activation sensor for Block Function.
Activation sensor for Stop Function.
Pilot indicator light Heat sustainment
Function activated *.
Pilot indicator light Boil control Function
activated*.
Pilot indicator light Block Function acti-
vated*.
Pilot indicator light Stop Function acti-
vated*.
Activation sensor for Boil control Func-
tion.
Activation sensor for Heat sustainment
Function.
"Less" sensor for timer.
"More" sensor for timer.
Decimal point.
Total Zone function sensor.
Pilot indicator light Total Zone Function
activated*.
- Light (on): Plate selected (ready to be
used).
- No light (off): Plate not selected (can't be
used).
NOTE: * Visible only when in use.
Operations are carried out by using the
sensors marked on the control panel.
It's not necessary to push hard on the
glass. Simply place your finger on the sen-
sor to activate the desired function.
Use the cursor slider (2) to adjust power
levels (
0 - 9, and P) by sliding your finger
over it. Sliding towards the right increases
the value, whereas sliding towards the left
decreases it.
It's also possible to directly select a power
level by placing your finger directly on a
desired point of the cursor slider.
In order to select a plate on these
models, directly touch the POWER
INDICATER NUMBER (3).
Use and Maintenance
16
12
13
14
15
1
2
3
4
5
6
8
7
10
11
9
17
fig. 4
The aesthetics
of the Touch
Control may
vary according
the model.
18