User's Manual

19
BAUMATI C BDW13, BDW14 dishwasher user manual
BEFORE YOU CALL FOR SERVICE …
CHECKING AGAINST THE CHARTS BELOW MAY FIX YOUR PROBLEM.
PROBLEM POSSIBLE CAUSES WHAT TO DO
• Replace fuse or reset circuit
breaker.
• Fuse blown, or the
circuit
breaker acted
• Remove any other appliances
feeding
from the same socket as
the
dishwasher .
• Power supply is not
turned
on
• Make sure the dishwasher is turned
on
and the door is closed securely .
• Check that the water supply is
connected
properly and the water is
turned
on.
• Water pressure is low
down the De l ay Timer key at the
• For situation A , Press and hold
• … And ( situation A )
the
number 17 is
showing
on the
display.
This means
that
your dishwasher
has
entered Test
Mode
– a factory
sequence
which you
need
not concern
yoursel
f with . This
happens
because the
Delay T i mer key was
pressed
before the
Dishwasher
doe
sn’t run!
same time as you’re pressing the
‘ ON/OFF’ button to switch the
dishwasher off. Wait a few
seconds then press only the
‘ON/OFF’ button again . You are
now ready to program your
dishwasher for a washing cycle as
per usual.
‘ON/OFF ’ key was
pressed.
• For situation B , Press ‘ ON / OFF’
button
to turn the dishwasher off.
Then
, press and hold down the
Program Key (‘P’) at the same
time
as you’re pressing the ‘ON /
• … Or ( situation B )
OFF’ button to switch the
the display shows one
of
the following: 0A,
dishwasher on again . You are now
ready to program a cycle as per
09, 08, 07, 06, 05,
usual.
04, 03, 02, 01, 00 .
• The system is designed to detect an
overflow.
When it does, it shuts off
Drain Pump
doe
sn’t stop!
• Overflow the circulation pump and turns on
the drain pump. Call a Baumatic
Ltd approved technician .
19