Operating instructions

BAUMATIC BDW15 dishwasher user manual
24
24
ERROR CODES - WHAT THEY MEAN
* YOUR DISHWASHER MAY EXPERIENCE A FAULT. SHOULD THIS HAPPEN, A
CODE CONSISTING OF ‘E’ & A NUMBER FROM 1-7 CAN BE DISPLAYED.
USE THIS TABLE TO UNDERSTAND WHAT IS WRONG.
*NOTE*: ALWAYS CALL FOR A Baumatic Ltd ENDORSED / APPROVED
SERVICE TECHNICIAN TO CARRY OUT REPAIRS.
CODE SYMPTOM: CAUSE: WHAT TO DO:
‘E1’
LONGER FILL TIME. FAUCET IS NOT OPENED.
Ensure that inlet hose is not
kinked or crushed.
‘E2’
LONGER or EXTENDED DRAINING TIME
THE DRAIN PIPE WAS PLACED
TOO HIGH WHEN IT WAS
INSTALLED.
Ensure drainage system is as
per manual and not
extended.
‘E3’
LONGER HEATING TIME – NOT
REACHING REQUIRED TEMPERATURE
MALFUNCTION OF
TEMPERATURE SENSOR OR OF
HEATING ELEMENT.
CALL FOR A QUALIFIED
SERVICE TECHNICIAN.
‘E4’
OVERFILLED
TOO MUCH INLET WATER.
*NOTE * - THERE ARE
NUMEROUS CAUSES OF AN ‘E4’
MESSAGE. REFER TO
APPLIANCE USAGE SECTION
OF THIS MANUAL FOR
GUIDELINES ON HOW TO
PREVENT AN OVERFILL.
Overdosing. 3-in-1 put in
with salt and/or rinse aid in
the appliance =overdose.
Could also be a Water
Pressure problem.
‘E5’
*
SWITCH CANNOT SHUT OFF
AUTOMATICALLY – PROGRAM NOT
FINISHING ITS CYCLE.
LOW VOLTAGE OR POWER
SWITCH FAILURE.
*** NOTE – YOU WILL NOT
RUN INTO THIS ERROR ON THE
BDW13/14/15 MODELS ****
CALL FOR A QUALIFIED
SERVICE TECHNICIAN.
‘E6’
OPEN CIRCUIT THERMISTOR.
CALL FOR A QUALIFIED
SERVICE TECHNICIAN.
‘E7’
SHORT CIRCUIT THERMISTOR.
CALL FOR A QUALIFIED
SERVICE TECHNICIAN.
WARNING!
IF OVERFLOW OCCURS, TURN OFF THE MAIN WATER SUPPLY BEFORE CALLING A SERVICE
TECHNICIAN. IF THERE IS WATER IN THE BASE OF THE TANK PAN BECAUSE OF AN OVERFILL
OR SMALL LEAK, THE WATER SHOULD BE REMOVED BEFORE RESTARTING THE DISHWASHER.