User manual

12
If you can only find two wires in the cable (blue and brown), neither must be
connected to the Earth terminal!
 As the colours of the wires in the appliance‟s mains lead may not
correspond with the coloured markings identifying the terminals in
your spur box, please proceed as follows:
1）The BLUE WIRE must be connected to the terminal marked “N” (Neutral), or coloured Black
2）The BROWN WIRE must be connected to the terminal marked “L” (LIVE), or coloured Red
3）The Green/Yellow wire must be connected to the terminal marked “E” or
(Earth)(Fig 7 – at left) (Wire diagram-at right)
Installation Instructions
1. The ceiling must bear at least 40kgs weight, and the thickness of
the ceiling must be ≧30MM, see pic 2. Drill 1*170mm round hole in
the ceiling.
2. According to the hanging board, drill 12 holes in the ceiling, see pic 2.
12 ST6*40mm big flat screws will be used to fix the hanging board on
the ceiling, and then 8 M4*10 screws and a M4 nut with gasket will be
used to connect the angle iron into the hanging board, see pic 1. After
calculating the length of the angle iron, 16 M4*10 big flat screws and
a M4 nut with gasket should be used to connect the angle iron and
another angle iron ( the overlap length of angle iron can not be less
100MM).
3. Let one side of the extensible pipe go outside through the hole of
170MM, see pic 3.
4. 4 ST4*8 big flat screws will be used to connect the internal chimney
into the hanging board. Then put up the external chimney, two hooks
will be used to put up the external chimney in order to the next
installation, see pic 4.
5. 4 ST4*8 big flat screws will be used to install the outlet, see pic 5.
6. Adjust the 4 glass screws to check whether the glass and the cooker
hood body are connected well and fixed, see pic 6.
7. Hold up the hood, 16 M4*10 big flat screws will be used to connect
the hood body into angle iron, see pic 7.