User manual

35
o ld
ced on the
burner.
OU MUST follow the
inimum flow adjustment section below.
djustment for hob gas taps.
ust be carried out by a CORGI registered
ngineer.
o e knob
at the minimum position.
o
river in
the centre of the tap shaft.
o flow
or tighten the adjusting screw to decrease the gas flow.
o btained when the flame has a
length of about 3 – 4 mm.
o ropane gas, the adjusting screw must be tightly
screwed in.
o Refit the control knob.
o
e
flow, testing it again once the adjustment has been made.
o RTANT: On completion carry out a gas tightness
test.
Reassemble all the burners carefully; in particular you shou
make sure that the flame spreader is correctly pla
IMPORTANT: After changing the injectors Y
m
Minimum flow a
All work m
e
Light the burner and set th
Remove the knob from the tap and
place a small bladed screwd
Unscrew the adjusting screw, in order to increase the gas
The correct adjustment is o
For butane/p
Make sure that the flame does not go out by quickly turning
from maximum flow to minimum flow. If it does then remov
the control knob and make further adjustments to the gas
IMPO