Technical data

Instructions for use

These User Instructions should be retained for future reference and for use by any person who is

perhaps unfamiliar with the appliance.

USING THE HOB

B13 B14 B15 B16 & BF16

These models have a safety lock feature incorporated into the control panel This feature is

to prevent accidental use of the appliance, This can be done by first pressing the power On / Off key

and then the Lock Key, The lock function can also be applied to a cooking zone when in use, to

maintain a specific heat setting, this is done by selecting the required heat setting of the zone and then

by pressing the lock key it will lock the zone at that required setting. When applying the lock function

an audible bleep is emitted and the LED adjacent to the pad will illuminate. To switch off the lock

function press the Key symbol and again an audible bleep will be emitted and the adjacent LED will be

distinguished. To gain full adjustable heat control the zone must be re-selected.

ALL MODELS

To switch on the appliance press the On / Off pad for 3 seconds, an audible bleep will be emitted and

the adjacent neon light will illuminate. Also a zero illuminates in each power level display and the

adjacent neon indicators flash.

The next input selection must take place within 10 seconds otherwise the hob will switch off again.

You can now select the required cooking zone by pressing the appropriate zone identification key and

then selecting the required heat level using the

+ or - keys, The heat levels range from 1 minimum

through to 9 maximum.

Residual Heat Indicator

After use an

“H” will light in the power level indicator of the zone that has been in use

The residual heat indicator will remain illuminated until the temperature drops below 50° C, the

residual heat indicator may not illuminate if during the cooking period the temperature did not reach

50° C or above.

Double Cooking Zone

B15 B16 BF15 & BF16

The above models have a double cooking zone function giving a larger cooking area, to select the

double zone function first press the appropriate zone and using the

+ or – keys select the required heat

setting the inner section of the zone will become operational, To select the outer section of the zone

press the double zone key the outer section will now become operational and will be

indicated by the illumination of a second neon by the appropriate zone indicator and will

reach the same heat setting as the inner zone setting.