User manual

9
ACEManual rev.080614
Charging the Battery
Important: Before the first use, the Ace’s battery needs to be charged to full
capacity which can take up to four hours. To charge the battery, use the power
supply and power cord provided as follows: First connect the power cord end with the
small prong into the port at the end of the rectangular part of the power supply. Next,
plug the power supply cord into the power port on the Ace, which is located at the
bottom of the left side panel. Finally, plug the power supply into a power outlet.
Do not use the Ace while it is being charged for the first time. Later on, the device can
be used while it is being charged.
In general, charging a depleted Ace battery to full capacity takes approximately four
hours. A fully charged Ace battery lasts for about five hours of continued use.
For safety reasons, only the adapter supplied for the Ace by ABiSee, Inc. should be
used to charge the Ace device.
Extending Battery Life
To prolong battery life, unplug the Ace from the power source at least once a month
and operate it on battery power until the battery charge goes down to below 15%.
Battery Replacement
When the battery on your device has reached the end of its rechargeable life, a
replacement can be ordered either from the dealer who sold you the device or directly
from ABiSee. On the lower back side of the device, there is a battery compartment with
a cover that is attached by four small Phillips screws. To install the replacement battery,
unscrew the screws, and remove the battery. Position the new one like the original,
replace it and tighten the cover.
Navigation and Settings
This section explains Main Menu options and how to navigate through scanning and
reading and other functions. Let’s start by pressing the Home Button to get to the Main
Menu.
Main Menu Option List
 Scan and Read
 Calendar (Includes a reminder function)