User manual

9
ACEManual rev.092914
Checking the Battery Charge Status
To quickly check the battery status, press the round Center Daisy Button. An
announcement will tell you what menu screen you are in and the battery status.
The battery status is also given in the Settings sub-menu under Status. To get to the
Status menu from the Main Menu, scroll to and select Settings. Then scroll to and
select Status. (The percentage of available battery charge is announced and also
displayed in the screen). “100%” means a fully charged battery. If the charge is below
15%, it is time to recharge. The Ace can be used while it is being charged.
Charging the Battery
Important: Before the first use, the Ace’s battery needs to be charged to full
capacity which can take up to four hours. To charge it, use the power supply and
power cord provided as follows: First connect the power cord end with the small prong
into the port at the end of the rectangular part of the power supply. Next, plug the
power supply cord into the power port on the Ace. Finally, plug the power supply into a
power outlet.
Do not use the Ace while it is being charged for the first time. Later on, the device can
be used while it is being charged. In general, charging a depleted Ace battery to full
capacity takes approximately four hours. A fully charged Ace battery lasts for about five
hours of continued use.
For safety reasons, only use the adapter supplied for the Ace by ABiSee, Inc.
Battery Replacement
When the battery on your device has reached the end of its rechargeable life, a
replacement can be ordered either from the dealer who sold you the device or directly
from ABiSee. On the lower back side of the device, there is a battery compartment with
a cover that is attached by four small screws. To install the replacement battery,
unscrew the screws, and remove the battery. Position the new one like the original,
replace it and tighten the cover.
Navigation and Settings
This section details all the Main Menu options and how to navigate through scan and
read and other functions. Let’s start by pressing the Home Button to get to the Main
Menu.